ML_ERROR2= Data Set Option

Specifies the name of a temporary table that MultiLoad uses to track errors that were generated during the application phase of a bulk-load operation.

Valid in:	DATA and PROC steps (when creating and appending to DBMS tables using SAS/ACCESS software)
Default:	none
Restriction:	Do not use ML_ERROR2 with ML_LOG=, which provides a common prefix for all temporary tables that the Teradata MultiLoad utility uses.
Requirements:	To specify this option, you must first set MULTILOAD=YES. When you restart a failed MultiLoad job, you must specify the same application table from the earlier run so that the MultiLoad job can restart correctly. Using ML_RESTART=, ML_ERROR1=, and ML_WORK=, you must also specify the same log table, acquisition error table, and work table upon restarting.
Data source:	Teradata
See:	ML_ERROR1= data set option, ML_LOG= data set option, , ML_RESTART= data set option, ML_WORK= data set option, MULTILOAD= data set option, Using MultiLoad

Syntax

Details

Syntax

ML_ERROR2=temporary-table-name

Syntax Description

temporary-table-name: specifies the name of a temporary table that MultiLoad uses to track errors that were generated during the application phase of a bulk-load operation.

Details

Use this option to specify the name of a table to use for tracking errors that were generated during the application phase of the MultiLoad bulk-load operation. By default, the application error table is named SAS_ML_UT_randnum, where randnum is a random number.

For more information about temporary table names that the Teradata MultiLoad utility uses and what is stored in each, see the Teradata MultiLoad reference.