PROCESS

Specifies the command that translates the metafile into commands for the device.

Used by:	GDEVICE procedure, GDEVICE Metagraphics window
Restriction:	Used only with user-supplied Metagraphics drivers.
See:	INTERACTIVE

Syntax

PROCESS='command'

command: specifies the command that translates the metafile produced by the Metagraphics driver into commands for the device. The command runs your program to produce the output. Command is a string up to 40 characters long.

PROCESS is required if the value of the INTERACTIVE device parameter is PROC or GRAPH.

For information about Metagraphics drivers, contact Technical Support.