Tutorial: A Module for Linear Regression

The linear systems that arise naturally in statistics are usually overconstrained, meaning that the matrix has more rows than columns and that an exact solution to the linear system is impossible to find. Instead, the statistician assumes a linear model of the form

where is the vector of responses, is a design matrix, and is a vector of unknown parameters that are estimated by minimizing the sum of squares of , the error or residual term.

The following example illustrates some programming techniques by using SAS/IML statements to perform linear regression. (The example module does not replace regression procedures such as the REG procedure, which are more efficient for regressions and offer a multitude of diagnostic options.)

Suppose you have response data measured at five values of the independent variable and you want to perform a quadratic regression. In this case, you can define the design matrix and the data vector as follows:

proc iml;
x = {1 1 1,
     1 2 4,
     1 3 9,
     1 4 16,
     1 5 25};
y = {1, 5, 9, 23, 36};

You can compute the least squares estimate of by using the following statement:

b = inv(x`*x) * x`*y;
print b;

The predicted values are found by multiplying the data matrix and the parameter estimates; the residuals are the differences between actual and predicted responses, as shown in the following statements:

yhat = x*b;
r = y-yhat;
print yhat r;

To estimate the variance of the responses, calculate the sum of squared errors (SSE), the error degrees of freedom (DFE), and the mean squared error (MSE) as follows:

sse = ssq(r);
dfe = nrow(x)-ncol(x);
mse = sse/dfe;
print sse dfe mse;

Notice that in computing the degrees of freedom, you use the function NCOL to return the number of columns of and the function NROW to return the number of rows.

Now suppose you want to solve the problem repeatedly on new data. To do this, you can define a module. Modules begin with a START statement and end with a FINISH statement , with the program statements in between. The following statements define a module named Regress to perform linear regression:

start Regress;                    /* begin module        */
  xpxi = inv(x`*x);               /* inverse of X'X      */
  beta = xpxi * (x`*y);           /* parameter estimate  */
  yhat = x*beta;                  /* predicted values    */
  resid = y-yhat;                 /* residuals           */

  sse = ssq(resid);               /* SSE                 */
  n = nrow(x);                    /* sample size         */
  dfe = nrow(x)-ncol(x);          /* error DF            */
  mse = sse/dfe;                  /* MSE                 */
  cssy = ssq(y-sum(y)/n);         /* corrected total SS  */
  rsquare = (cssy-sse)/cssy;      /* RSQUARE             */
  results = sse || dfe || mse || rsquare;
  print results[c={"SSE" "DFE" "MSE" "RSquare"}
                L="Regression Results"];

  stdb = sqrt(vecdiag(xpxi)*mse); /* std of estimates    */
  t = beta/stdb;                  /* parameter t tests   */
  prob = 1-probf(t#t,1,dfe);      /* p-values            */
  paramest = beta || stdb || t || prob;
  print paramest[c={"Estimate" "StdErr" "t" "Pr>|t|"}
                 L="Parameter Estimates" f=Best6.];
  print y yhat resid;
finish Regress;                   /* end module          */

Assuming that the matrices x and y are defined, you can run the Regress module as follows:

run Regress;                     /* run module           */