ODS provides options for specifying the size and resolution of graphs. You can specify the size of a graph in the ODS GRAPHICS statement and the resolution in an ODS destination statement. There are two other ways to change the size of a graph, but they are rarely needed. The three methods are as follows:
Usually, you specify the WIDTH= or HEIGHT= option (or both) in the ODS GRAPHICS statement to change the size of a graph.
To modify the size of a particular graph, specify the dimensions with the DESIGNHEIGHT= and DESIGNWIDTH= options in the BEGINGRAPH statement in the template. Some templates contain the specification DESIGNWIDTH=DEFAULTDESIGNHEIGHT, which sets the width of the graph to the default height, or DESIGNHEIGHT=DEFAULTDESIGNWIDTH, which sets the height of the graph to the default width.
To modify the size of all of your ODS graphs, specify the dimensions with the OUTPUTHEIGHT= and OUTPUTWIDTH= options in the style template.
The following examples show typical ways to change the size of your graphs:
ods graphics on / width=6in; ods graphics on / height=4in; ods graphics on / width=4.5in height=3.5in;
The dimensions of the graph can be specified in pixels (for example, 200PX), inches (for example, 3IN), or centimeters (for example, 8CM). The default dimensions of ODS Graphics are 640 pixels wide and 480 pixels high, and these values determine the default aspect ratio. The actual size of the graph in inches depends on your printer or display device. For example, if the resolution of your printer is 100 dots per inch and you want a graph that is 4 inches wide, you should set the width to 400 pixels.
If you specify only one dimension, the other is determined by the default aspect ratio—that is, height=0.75 width. For best results, you should create your graphs by using the exact size that is used to display the graphs in your paper or presentation. In other words, avoid generating them at one size and then expanding or shrinking them for inclusion into the your document.
By default, fonts and symbol markers are automatically scaled with the size of the graph. You can suppress this scaling with the SCALE= option, as in the following example:
ods graphics on / scale=off;
The default resolution of graphs created with HTML and LISTING is 96 DPI (dots per inch), whereas the default with RTF is 200 DPI. The 200 DPI value is recommended if you are copying and pasting graphs into a Microsoft PowerPoint presentation or a Microsoft Word document. Graphs shown in SAS/STAT documentation are typically generated at 300 DPI for display in PDF and 96 DPI for display in HTML.
You can change the resolution with the IMAGE_DPI= option in any ODS destination statement, as in the following example:
ods html image_dpi=300;
An increase in resolution often improves the quality of the graphs, but it also greatly increases the size of the image file. Going from 96 DPI to 300 DPI increases the size of the image file by roughly a factor of . Even when you are using a higher DPI for most of your graphs, you should consider using a lower DPI for some, such as contour plots, that create large files even at a lower DPI.
If you increase the resolution, you might need to compensate by reducing the size of the graph, as in the following example:
ods graphics on / width=4.5in height=3.5in;
Increasing DPI also increases the amount of memory needed for your program to complete. You can increase the amount of memory available to ODS Graphics with an option when you invoke SAS, as in the following example:
-jreoptions '(-Xmx256m)'
You can modify the default amount of memory available to ODS Graphics by changing JREOPTIONS in your SAS configuration file to the settings –Xmxnnnm –Xmsnnnm, where nnn is the amount of memory in megabytes. An example is –Xmx256m –Xms256m. In either case, the exact syntax varies depending on your operating system and the amount of memory that you can allocate varies from system to system. For more information, see the SAS Companion for your operating system.