In general, the process
for installing and configuring all SAS products is the same. You can
perform this installation and configuration by using the SAS Deployment
Wizard.
However, some products
require that you perform steps before upgrading to a new release or
perform post-configuration steps after installing the product. The
“Product Details and Requirements” section of this document
contains information about product changes and any pre-installation
and post-configuration steps that you need to perform for a specific
SAS product. Each chapter begins with an upgrade path table. In the
table, find the row for your current release and the release that
you are upgrading to. The last column in that row contains the high-level
steps that you must perform to install and configure a SAS product. It
is important that you review the documentation for all products at
your site before updating the software at your site, so you can create
a complete installation and configuration checklist for your site.
If a product is not
listed in this part, then no pre-installation or post-configuration
steps are required.