PROBPLOT Statement: CAPABILITY Procedure

Note: See Creating Lognormal Probability Plots in the SAS/QC Sample Library.

When you request a lognormal probability plot, you must specify the shape parameter for the lognormal distribution (see Table 5.62 for the equation). The value of must be positive, and typical values of range from 0.1 to 1.0. Alternatively, you can specify that is to be estimated from the data.

The following statements illustrate the first approach by creating a series of three lognormal probability plots for the variable Diameter introduced in the preceding example:

proc capability data=Rods noprint;
   probplot Diameter / lognormal(sigma=0.2 0.5 0.8)
                       href = 95
                       square;
run;

The LOGNORMAL option requests plots based on the lognormal family of distributions, and the SIGMA= option requests plots for equal to 0.2, 0.5, and 0.8. The SQUARE option displays the probability plot in a square format and the HREF= option requests a reference line at the 95th percentile.

The resulting plots are displayed in Figure 5.35, Figure 5.36, and Figure 5.37, respectively. The value in Figure 5.36 produces the most linear pattern.

Based on Figure 5.36, the 95th percentile of the diameter distribution is approximately 5.9 mm, because this is the value corresponding to the intersection of the point pattern with the reference line.

The following statements illustrate how you can create a lognormal probability plot for Diameter using a local maximum likelihood estimate for .

title 'Lognormal Probability Plot for Diameters';
proc capability data=Rods noprint;
   probplot Diameter / lognormal(sigma=est)
                       href     = 95
                       odstitle = title
                       square;
run;

The plot is displayed in Figure 5.38.

Note that the maximum likelihood estimate of (in this case 0.041) does not necessarily produce the most linear point pattern. This example is continued in Example 5.20.